Call Us Today!
1-919-535-3180
sales@plcfactory.com

GE Fanuc Series 90-30 PLC

IC693MDL740 | GE Fanuc



Rate the IC693MDL740
Rated 3.5/5 based on 2 ratings.

In Stock

Ships Today!

Immediate Availablity: 123 Units!


Manufacturer GE Fanuc
Description 0.5 Amp, 12/24 Volts dc Output
Weight 2 lbs :: ≈ 1 kgs
Warranty 1 Years
Other Available Revisions of the IC693MDL740 : -,

12/24 Volt DC Positive Logic Output - 0.5 Amp, 16 Point IC693MDL740 The 12/24 volt DC Positive Logic 0.5 Amp Output module for the Series 90-30 Programmable Logic Controller provides 16 output points in two groups of eight with a common power output terminal for each group. This output module is designed to have positive logic characteristics in that it sources current to the loads from the user common or positive power bus. The output device is connected between the negative power bus and the module output. The output characteristics are compatible with a wide range of user-supplied load devices, such as: motor starters, solenoids, and indicators. Power to operate the field devices must be supplied by the user. LED indicators which provide the ON/OFF status of each point are located at the top of the module. This LED block has two horizontal rows with eight green LEDs in each row with the top row labeled A1 through 8 (points 1 through 8) and the bottom row labeled B1 through 8 (points 9 through 16). An insert goes between the inside and outside surface of the hinged door. The surface towards the inside of the module (when the hinged door is closed) has circuit wiring information, and circuit identification information can be recorded on the outside surface. The outside left edge of the insert is color-coded blue to indicate a low-voltage module. There are no fuses on this module. This module can be installed in any I/O slot of a 5 or 10-slot baseplate in a Series 90-30 PLC system. Table 7-12. Specifications for IC693MDL740 Rated Voltage 12/24 volts DC Output Voltage Range 12 to 24 volts DC (+20%, 15%) Outputs per Module 16 (two groups of eight outputs each) Isolation 1500 volts between field side and logic side 500 volts between groups Output Current 0.5 amps maximum per point 2 amps maximum per common Output Characteristics Inrush Current 4.78 amps for 10 ms Output Voltage Drop 1 volt maximum Off-state Leakage 1 mA maximum On Response Time 2 ms maximum Off Response Time 2 ms maximum Power Consumption 110 mA (all outputs on) from 5 volt bus on backplane Refer to Appendix B for product standards and general specifications. Discrete Output Modules 7 GFK-0898F Chapter 7 Discrete Output Modules 7-25 IC693MDL740 Output Module Field Wiring Information The following figure provides wiring information for connecting user supplied load devices and power source to the 12/24 volt DC positive logic - 0.5 amp output module.