GE-IP | 9030 | GE Fanuc 90-30 GE-IP PLC

IC693MDL734 Image


  • Availability: In Stock Ships Today!
  • Units in Stock: Immediate Availablity: 9 Units!
  • Call for best Pricing+ 1 919 680 1773
  • Manufacturer: GE-IP
  • Description: 125 Volts dc Output, (6)
  • Weight: 1 lbs :: ≈ 1 kgs
  • Warranty: 1 Years
  • Product Revisions Available:
  • Other Available Revisions of the IC693MDL734 : A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z,

Product Manual Excerpt

125 Volt DC Positive/Negative Logic 1 Amp Output - 6 Point IC693MDL734 The 125 volt DC Positive/Negative Logic 1 Amp Output module for the Series 90-30 Programmable Logic Controller provides 6 isolated output points . Each output has a separate common output terminal associated with it. This output module is designed to have either positive logic characteristics in that it sources current to the loads from the user common or positive power bus; or negative logic characteristics in that it sinks current from the loads to the user common or negative power bus. The output characteristics are compatible with a wide range of user-supplied load devices, such as: motor starters, solenoids, and indicators. Power to operate the field devices must be supplied by the user. LED indicators which provide the ON/OFF status of each point are located at the top of the module. This LED block has two horizontal rows with eight green LEDs in each row. This module uses the first six LEDs in the top row, labeled A1 through 6 (points 1 through 6) for output status. An insert goes between the inside and outside surface of the hinged door. The surface towards the inside of the module (when the hinged door is closed) has circuit wiring information, and circuit identification information can be recorded on the outside surface. The outside left edge of the insert is color-coded red to indicate a high-voltage module. External fusing is recommended. Two amp loads can be driven by wiring and driving two outputs in parallel. This module can be installed in any I/O slot of a 5 or 10-slot baseplate in a Series 90-30 PLC system. Table 7-11. Specifications for IC693MDL734 Rated Voltage 125 volts DC Output Voltage Range +10.8 to +150 volts DC Outputs per Module 6 (isolated) Isolation 1500 volts between field side and logic side 500 volts between outputs Output Current 1 amp maximum per point Output Characteristics Inrush Current 15.89 amps for 10 ms Output Voltage Drop 1 volt maximum Off-state Leakage 1 mA maximum On Response Time 7 ms maximum Off Response Time 5 ms maximum Power Consumption 90 mA (all outputs on) from 5 volt bus on backplane Refer to Appendix B for product standards and general specifications. Discrete Output Modules 7 GFK-0898F Chapter 7 Discrete Output Modules 7-23 IC693MDL734 Output Module Field Wiring Information The following figure provides wiring information for connecting user supplied load devices and power source to the 125 volt DC positive/negative logic 1 amp output module. LOGIC LOGIC Figure 7-20. IC697MDL734 Output Module Field Wiring 6 4 2 10 C 20 C 30 C 40 C 50 C 60 C TOTAL MODULE LOAD CURRENT AMBIENT TEMPERATURE ( C) 5 3 1 6 AMPS a45240 (AMPS) Figure 7-21. Load Current vs. Temperature for IC693MDL734